My
User Center 
You are here :Home > Exam information > Designing Cisco Enterprise Networks 300-420 ENSLD Certification Dumps
Designing Cisco Enterprise Networks 300-420 ENSLD Certification Dumps
April 08,2021
The new updated Designing Cisco Enterprise Networks 300-420 ENSLD Certification Dumps are available, which contain 102 Q&As. With studying all of the updated Cisco CCNP Enterprise 300-420 ENSLD exam certification dumps, you can pass this Designing Cisco Enterprise Networks exam easily. The official Cisco certification 300-420 ENSLD exam information is also an important in your preparation.
Designing Cisco Enterprise Networks 300-420 ENSLD Exam
Cisco 300-420 ENSLD exam is a 90-minute exam associated with the CCNP Enterprise and Cisco Certified Specialist-Enterprise Design certifications. Designing Cisco Enterprise Networks 300-420 ENSLD exam certifies your knowledge of enterprise design including advanced addressing and routing solutions, advanced enterprise campus networks, WAN, security services, network services, and SDA. You can schedule Cisco 300-420 ENSLD exam at Pearson VUE test center.
Cisco 300-420 ENSLD Exam Topics
Cisco CCNP Enterprise 300-420 ENSLD exam topics cover the following sections.
Study Updated Cisco 300-420 ENSLD Certification Dumps
300-420 ENSLD Designing Cisco Enterprise Networks certification dumps updated version is the best material for you to test the above topics. Share some Cisco 300-420 ENSLD certification updated dumps with you below.
1.In an SD-WAN architecture, which methods are used to bootstrap a vEdge router?
A. DHCP options or manual configuration
B. vManage or DNS records
C. ZTP or manual configuration
D. DNS records or DHCP options
Answer: C
2.When vEdge router redundancy is designed, which FHRP is supported?
A. HSRP
B. OMP
C. GLBP
D. VRRP
Answer: D
3.What is an advantage of designing an out-of-band network management solution?
A. In the event of a production network outage, network devices can still be managed.
B. There is no separation between the production network and the management network.
C. In the event of a production network outage, it can be used as a backup network path.
D. It is less expensive than an in-band management solution
Answer: A
4.Which common issue causes intermittent DMVPN tunnel flaps?
A. a routing neighbor reachability issue
B. a suboptimal routing table
C. interface bandwidth congestion
D. that the GRE tunnel to hub router is not encrypted
Answer: A
5.How is sub-second failure of a transport link detected in a Cisco SD-WAN network?
A. Hellos are sent between the WAN Edge routers and the vSmart controller.
B. BFD runs on the IPsec tunnels between WAN Edge routers.
C. BGP is used between WAN Edge routers and the vSmart controller.
D. Link state change messages are sent between vSmart controllers.
Answer: B
- Related Exam Information
- CCNP Routing and Switching to New CCNP Enterprise Certification April 09,2020
- 300-135: Troubleshooting and Maintaining Cisco IP Networks (TSHOOT) December 12,2019
- CCNP Data Center certification November 28,2019
- 300-209: Implementing Cisco Secure Mobility Solutions November 21,2019
- CCNA Cyber Ops certification exam November 14,2019
- CCNP Collaboration certification November 07,2019
- The common questions of 210-260 IINS exam October 24,2019
- 210-451: Understanding Cisco Cloud Fundamentals October 17,2019
- How to Pass 840-450 Exam with New Released 840-450 DTBAD Certification Dumps? June 14,2018
- Updated Cisco 300-615 DCIT Certification Dumps May 06,2021
- Updated Cisco 300-710 SNCF Certification Dumps April 15,2021
